15076 Autoloader ALE: trailing edge clamps not on actuator All If all the clamps are in place, check for faulty magnet sensor by using "tec" command. If it is faulty, use "set al ms 0" to bypass the sensor and get the customer going. Arrange for field service. Check if all the clamps are on the actuator. Place any missing clamp onto the actuator and select resume. Missing clamp on the TEC actuator Faulty TEC magnet sensor ../nvs/al_cal_ms.xmlNVS: al ms ../commands/tec.xmlCommand: tec ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:51 2008 PST